Limited-Edition Pink BendPak 10APX High-Rise Two-Post Lift

10APX Series: Tall-Rise Lifts

Meet the 10APX Pink Edition. Built for techs who need more headroom and faster setups. Lift height is 79.5 in. Overhead beam is 157 in. The 10APX-181 keeps the same lift height and stretches the overhead beam to 181 in so you can work comfortably on high-roof cargo vans. You still get a 10,000 lb capacity, Low-Pro arms, Bi-Metric™ loading, and the AP Series engineering you trust. Limited pink finish for Breast Cancer Awareness Month. Available only in October.

BendPak will donate 10% of the product price from each pink 10APX sold between Oct 1 and Oct 31, 2025 to METAvivor Research and Support, Inc. Donation is calculated before tax and shipping. Returns or cancellations reduce the total.

A New Paradigm in Lifting

AP Series lifts factor the best qualities of modern two-post designs into a future-ready platform. Configure wide or narrow to fit your bay. Load symmetric or asymmetric with Bi-Metric™ arms without swapping hardware. The layout is simple to service which lowers maintenance cost and helps you move more vehicles per day.

New Technology for Increased Operator Safety

Vehicles are getting heavier. Electric Vehicles add significant mass. The AP platform is engineered for these loads with high tensile-strength steels at critical points and geometry that keeps arms stable under push and pull forces. The goal is straightforward. Safer lifts. More control. Less downtime.

Electric Vehicles are Larger and Heavier. Be Ready.

The 10APX is tuned for EVs, trucks, vans, and low-ground-clearance sports cars. Extra-wide column spacing improves under-car access. Low-Pro arms and greater arm travel reach outer lift points cleanly. Patented nesting in the triple-stage arms delivers more retraction and more reach so tough lift points are easier to hit. Safety-critical upgrades run throughout the system.

Automatic Arm Restraint System Prevents Unplanned Movement

Our patented Automatic Swing Arm Restraint System helps prevent arm shift during loading and service. Forged steel components deliver full 360 degree load holding grip with more than 2,000 lb of holding force per arm. The system adapts with minimal operator input and includes a quick release lever for fast repositioning when the vehicle is back on the ground.

Triple-Telescoping Nested Swing Arm Design

Patented triple-stage arms retract shorter and extend farther than traditional arms. Inner tubes clear end plates and even the pivot pin which gives you real working range at both extremes. Operators get more positioning options and faster setups.

Low Profile Arms

Exclusive Low-Pro™ swing arms use shorter-profile channels and a dropped pad receiver. That means easier access to low lift points and less risk to side skirts, running boards, and ground effects. Stackable adapters and spin-up screw pads dial in height for precise, safe support.

Screw Pads and Adapters that Adjust to Your Needs

Double-telescoping screw adapters with polyurethane pads fine tune height for level lifts and secure frame contact. Optional 2.5 in and 5 in stackable adapters add vertical reach. Drop-in design speeds setup and column-mounted racks keep adapters organized.

Innovative Safety Lock System

The automatic safety lock system engages on every rise. A single-point release lets you lower with one finger. Simple. Proven. Effective.

Bi-Metric™ Swing Arms

Adaptable Bi-Metric™ arms let you load symmetric at the column centerline or asymmetric behind the column. No arm changeout required which helps you move cars through the bay faster.

This product is protected by patent in the United States (Patent No. US11820632B2), Canada, China, and other countries where corresponding patent protection has been sought.