18,000-lb. Capacity / Rolling Bridge Jack
The powerful 18,000-lb. capacity RBJ18000 rolling bridge jack is made for use with your HDS-35 or HDS-40 four-post lift series. Sometimes a vehicle’s center of gravity that isn’t in the exact middle of the vehicle. In this case, even a 30,000-lb. vehicle might require a jack that is rated for more than half the vehicle’s weight.
Starting at $5055
Pay Over Time
with the Synchrony Car Care™ Credit Card.
Convenient monthly payments make your equipment purchase simple.Learn More
Lift 18,000 lbs. for Full Wheel Service Capability
While the 18,000-lb. capacity RBJ18000 will handle the weight of many heavy-duty vehicles, some larger trucks, buses and commercial drivers have significantly offset centers of gravity. It’s important to ensure your bridge jack is rated for the entire weight of both the front and back axles of the vehicle. The extra lift capacity of the RBJ18000 will compensate for a shifted center of gravity in heavy-duty vehicles being raised on the HDS-35 or HDS-40 four-post lift series.
Steel contact pads
BendPak bridge jacks feature steel contact pads that are built to withstand heavy use. The four steel contact pads on each rolling bridge jack are in place to support both the axel and the lifting points of your vehicle. The jack is low-profile, so the pads fit comfortably underneath low-stance cars.
High-pressure hydraulic power unit
The power unit on the RBJ18000 is strong enough to lift those massive city buses and farm equipment you’re raising on your HD-35 four-post lift. A simple foot pedal controls the jack, which reaches its max extension in seconds flat.
Three lock levels
Your work, your shop. With three lock positions, your rolling bridge jack adapts to the way you get things done. Different factors change your working height: operator preference, operator height, vehicle clearance, ceiling height and more. With three lock positions on the jack, your ultimate working height is that much more versatile.
Features & Specs
- 18,000-lb. lifting capacity
- Steal contact pads
- High-pressure hydraulic power unit
- Optional air-line kit
Min. Drive-Over Height*
Max. Lifting Height*
* Dimensions listed are taken from the upper surface of the suitable four-post lift runway.
Included commercial-grade air-hydraulic pump requires 125 psi and 10 – 20 CFM.
Note: Not all BendPak lift models meet the standards as prescribed by ANSI/ALI ALCTV-2017 or ANSI/UL 201. Consult www.autolift.org for a complete list or contact BendPak via email@example.com.
BendPak lifts are supplied with concrete fasteners that meet the criteria of the American National Standard ANSI/ALI ALCTV-(Current). Buyer is responsible for all charges relating to any special regional structural or seismic anchoring requirements specified by any other agencies or codes such as the Uniform Building Code (UBC) or International Building Code (IBC).
WARNING: California Prop 65