Skip to content

Instant Rebate Savings • 0% Financing • Ends Sept 30

SHOP NOW

Important Safety Notice

Stop Use Required for Certain BendPak MDS-6LP and MDS-6LPF

Date: May 30, 2026

Notice ID: TSB 199-032026

Failure to follow this notice may result in equipment not meeting applicable safety standards.

BendPak has identified a standards compliance condition affecting certain MDS-6LP and MDS-6LPF mid-rise vehicle service lifts manufactured on or after April 1, 2022. Affected lifts must be taken out of service immediately until the required corrective action has been completed.

Request Field Fix Kit

Reason for This Notice

Safety standards and certification requirements continue to evolve across the vehicle lift industry. BendPak regularly reviews its products against applicable standards and works with industry organizations, including the Automotive Lift Institute (ALI), to identify and address compliance matters when they arise.

Following a review conducted in conjunction with ALI, BendPak determined that certain affected lifts do not conform to the requirements of ANSI/ALI ALCTV:2017.

Specifically, the applicable ANSI/ALI ALCTV:2017 standard limits the vertical distance between the maximum rise height and the uppermost Load Holding Device (LHD) position to 6 inches. In affected units, this distance may exceed 9 inches.

This condition may increase the risk of unintended movement or instability if the lift is raised to maximum height without proper mechanical engagement.

BendPak is taking corrective action to bring affected units into compliance with the applicable standard.

Affected Models

  • BendPak MDS-6LP

  • BendPak MDS-6LPF

Affected production range: Manufactured on or after April 1, 2022

Do not assume your lift is unaffected without verification. If you are unsure whether your lift is affected, contact BendPak using the information below.

Required Action

  • Stop using the lift immediately.

  • Do not return the lift to service until the corrective action has been completed.

  • Install the provided Cylinder Limit Collar Kit in accordance with Technical Service Bulletin

    TSB 199-032026: MDS-6LP/LPF Cylinder Limit Collar Installation

    .

This procedure adjusts the lift’s maximum rise to ensure proper engagement and spacing relative to the uppermost safety lock position, bringing the unit into compliance with applicable standards.

Dealer Responsibility

Authorized BendPak dealers who sold affected units are required to:

  • Notify all customers who purchased affected lifts.

  • Provide customers with this Safety Notice and the accompanying Technical Service Bulletin.

  • Assist, where applicable, in coordinating corrective action.

Identification Number

This campaign has been assigned TSB 199-032026.

This number must be referenced in all communications, service records, and claims related to this notice.

Important Notes

  • Do not assume your lift is unaffected without verification.

  • Installation should be performed by qualified personnel.

  • Follow all safety procedures outlined in the Technical Service Bulletin, including lockout/tagout requirements.

  • Failure to perform this correction may result in unsafe operating conditions.

BendPak reserves the right to update or revise this notice. The most current version is available at: www.bendpak.com/notices.

Request Your Free MDS Field Repair Kit

To receive your required Cylinder Limit Collar Kit at no cost, complete the short form below to verify your lift information. After submitting the form, you’ll be directed to checkout to place your free kit order. There is no charge for the kit.